WoodGuard® Revitalizer removes oxidized cells caused by time and weather giving wood a new lease of life. WoodGuard® Revitalizer penetrates wood fibres and quickly eliminates the grey appearance, stains and dirt without affecting the woods aesthetics and colour. WoodGuard® Revitalizer does not contain solvents or chlo-rinated components. The acid component of this product is present in many plants (bean, spinach, cocoa...), and also in wine. WoodGuard® Revitalizer can be applied to dry or slightly damp wood.
WoodGuard®Revitalizer can be used outdoors to clean paneling, garden furniture, woodwork, shutters, wood gratings, fences, deckings, terraces.
Non flammable.
Easy and quick to apply.
Ready to use.
Can be used on all species of wood and coatings.
Water-based product.
Petroleum solvent-free.
Revives greying woods.
Efficient in 15 minutes.
Apply with a brush.
Tools and equipment should be cleaned with water immediately after use.
Use neat: do not dilute.
Shake the product well before use.
Always carry out a preliminary test.
Generously apply to the wood to be treated.
Always apply from top to bottom.
In the event of application on furniture and intricate woodwork or small surface, apply little by little using a brush or a paintbrush.
Allow the product to act for 10 to 15 minutes, and then rinse thoroughly with water until the product is fully eliminated.
Scrubbing with a nylon brush may improve the effec-tiveness of the product.
If necessary, reapply the product following the same procedure.
Let the wood dry and apply a apply one of our products from the WoodGuard® or WoodGuard®Color range to protect wood.
Physical state at 20°C: Viscous liquid.
Colour: Clear.
Odour: Light.
pH: 2 ± 0.5.
Boiling point [°C]: 100°C.
Relative density: 1.04 ± 0.015.
Solubility in water [vol/vol]: Total.
Flashpoint [°C]: Not applicable.
VOC rate: < 50 g/L*.
Coverage depends on the degree of soiling. The following values are for guidance only: 5 to 8 m2/litre.
2 and 5 litres.
Store in a dry place at a temperature of between 5°C and 30°C.
Shelf-life: 24 months from date of manufacture, in original unopened can.
Do not apply in rainy or hot weather. Surface and air temperature should be between 5°- 30°C.
Do not dilute or mix with other products.
Corrosive product: it is recommended to wear sa-fety goggles, gloves and protection clothing.
Protect vegetation.
WoodGuard®Revitalizer does not remove the green traces on autoclave wood.
Rinse thoroughly with water before applying antoher coating.
In case of brushing or rinsing with a high pressure washer, always follow the wood grain.
Do not lay the wood to be treated onto surfaces in order to avoid it becoming soiled.
WoodGuard®Revitalizer can be used on PVC sur-faces.
If crystals appear after drying, rinse them away with water.
Breathing protection: No breathing protection equipment is required under normal use conditions with suitable ventilation.
Hand protection: Wear chemical resistant gloves (neoprene, PVC).
Important: The content of this documentation is based on our experience with the product. Guard Industry guarantees the quality of its products but expresslydisclaims all liability if the user does not follow the recommendations and conditions of use of the products, especially but not exclusively in the case of faultyapplication, application by untrained personnel, use of products not compatible with Guard Industry products, or adverse weather conditions For more information, consult the safety data sheet.
.jpg)
Ho Chi Minh
